4 Solutions to Acronis True Image WD edition clone not working This situation is very similar to the second one, but this problem is related to a USB cable connected to a WD disk. Acronis True Image WD edition installation restricted - this product edition requires at least one Western Digital drive to be installed in your system. So, you need to format exFAT to FAT32 or NTFS or turn to a professional disk cloning software like AOMEI Backupper Professional.Įxplain: The most possible cause is that the drive does not have a valid MBR or third-party software is blocking access to hard disk drives. Situation 2. Acronis not recognizing WD HDD/SSD. Acronis True Image WD edition does not support the exFAT file system, so Acronis won’t recognize it and you cannot use a hard drive formatted as ExFAT as the target drive. And most of the modern digital drive is formatted with exFAT. To clone disk, you should turn off the secure boot first. Secure boot is a security measure built into a system's BIOS to prevent untrustworthy firmware from running. However, your computer may not reboot to the recovery environment.Įxplain: In this case, you probably enable the secure boot in BIOS, but it does not allow this boot path as part of the cloning process. Acronis True Image not cloning after restart. When you clone disk using Acronis True Image within Windows, you will be asked to restart the computer. 3 situations to Acronis True Image WD edition will not clone Keep reading below to learn the different situations and solutions to Acronis True Image WD edition clone not working. Why Acronis WD clone failed? Is it possible to fix it? If not, is there any alternative WD disk cloning software?” – Sunny Bonnell” – Sunny Bonnellĭon't worry about too much and I'll show you how to fix it in this article. But Acronis True Image not cloning after restart. Just the ones that are related to the OS.“I got a new SSD from Western digital and then downloaded the cloning software from their website, but this software always tell me ”Acronis computer restart is required” Whenever I try to clone hard drive with it. On the negative side, if you create an image of an older install that may have malware, glitches or bugs on it you'll be installing that to the new drives as well.Īs far as the OP is concerned, You don't need to clone every partition. If something ever goes wrong to the point the OS needs a reinstall I will use the image to restore the system back to a clean, fresh install the day I built it. When I build PC's for myself and co-workers (about 7k people where I work) I will install the OS, drivers and any software they will be using then create a backup image of the system. I've been using Acronis for about 10 years, and have cloned 200+ hard drives for myself and others and never had an issue (as long as the clone is being used for the same PC / hardware it came from) Are you using a caddy for the SSD/HDD on your laptop? Cloning often fails for most and it ends up borking everything. I simply backup all critical content from the OS drive(on the HDD) and then with the SSD connected, format the initial OS drive and reinstall the OS on the SSD.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |